Pork Tenderloin With Walnut Curry Stuffing and Red Currant Glaze
- Ready In:
- 30mins
- Ingredients:
- 16
- Serves:
-
4-6
ingredients
- 4 tablespoons butter
- 4 cups walnut halves
- 2 teaspoons curry
- 2 tablespoons olive oil
- 1 -2 tablespoon fresh minced garlic
- 2 (1 1/2 lb) pork tenderloin
- 3 teaspoons coriander
- 2 teaspoons cumin
- 2 teaspoons salt
- 1⁄2 - 1 teaspoon black pepper
-
GLAZE
- 2 (12 ounce) jars red currant jelly
- 1 tablespoon cooking sherry
- 1⁄2 teaspoon dry crushed red pepper
- 2 teaspoons apple cider vinegar
- 1 teaspoon ginger powder
- 1⁄4 cup shallot, finely chopped
directions
- Set oven to 350°F.
- Grease a 13 x 9-inch baking dish.
- For the pork; melt the butter in a small skillet over medium heat; add in the 4 cups walnut halves, cook stirring for about 1-2 minutes or until lightly toasted; reserve 1 cup for garnish.
- Place the remaining walnuts, curry powder, oil and garlic in a food processor; cover and process until finely ground (about 5-7 seconds).
- Butterfly the pork tenderloins by slicing along the length with a sharp knife to within 1/2-inch.
- Press open then evenly divide and spread the walnut mixture down the center.
- Pull pork together, then secure with skewers, or tie with cooking string.
- In a bowl combine the coriander, cumin, salt and back pepper in a small bowl; rub evenly over the tenderloins.
- Place the pork seam-side down in the baking pan.
- At this point you can cover and refrigerate the stuffed pork for up to 24 hours before roasting.
- Bake for about 1 hour or until the internal temperature reaches 170 degrees.
- Remove from oven and allow to rest while preparing the glaze.
- For the glaze; combine the jelly, sherry, crushed red pepper, vinegar, ginger and shallots in a small saucepan; bring to a boil, reduce heat to low, cook stirring occasionally for about 5 minutes; cover to keel warm.
- Slice the pork into about 1/2-inch slices.
- Arrange 2-3 pieces per plate.
- Spoon the glaze over pork, then sprinkle with reserved toasted walnuts.
- Delicious!
Questions & Replies
Got a question?
Share it with the community!